You can verify that your device has been registered with the licensing authority by checking your smart account. This should be a one-time configuration however if you are running demo licenses for labs or your network encounters instances where communication is lost, you may need to re-register the token.Ĭiscoasa(config)# license smart register idtoken force Verify Smart License This will be used to call-home and apply the license as well as assigning the device to the correct virtual account. Now that we have configured our smart license settings on the device, we need to register the previously requested ID token to the device. For the ASAv license I have, I will configure the following:Ĭiscoasa(config-smart-lic)# feature tier standardĬiscoasa(config-smart-lic)# throughput level 1G
Check your Smart License account to verify your surplus license availability if you are unsure. In this step we will configure the ASAv license entitlements based on the license purchased.
If your device is sat behind a proxy then follow these configuration steps Ĭiscoasa(cfg-call-home)# http-proxy 1.1.1.1 port 443 (Enter your proxy IP address and port) In this section I will run through the configuration for the ASAv. Step 2: Configure ASAv for Smart Licensing All commands and output from this point will be related to the ASA so please seek out further advice if you wish to configure another device as configuration may be slightly different. You should now have a token created which can be copied over to the device you wish to license. Once you are happy with your token settings click Create Token. Follow the steps below to create a new token.Ĭlick Inventory > General > New Token and select your preferred options and enter a description for your token. You will now need to create an ID token for your device, this is required for communication between the device and the licensing authority. Sign into your Cisco Software Portal: and navigate to “Smart Software Licensing” This post assumes that readers already have access to there own Smart Account and would like to know the process of applying licenses. In this article, I would like to demonstrate how to configure Cisco Smart Licensing on the virtual Cisco Adaptive Security Appliance (ASAv).
0 kommentar(er)
